Mains Connection And Line-Side Power Components; Introduction - Siemens SINAMICS S120 Equipment Manual

Mains connection and line-side power components

4.1

Introduction

The following line-side components should be used to connect a SINAMICS drive to the line
supply:
● Line disconnector
This does not have been a separate component, but can also be a fused disconnector or
load disconnector.
● Overcurrent protection device (line fuses or circuit-breaker)
● Line contactor (optional)
● Line filter (optional)
● Line reactor for FSA to FSC (optional)
The possible supply voltages for the drive are:
● For PM240-2 FSA, FSB and FSC Power Modules, blocksize format:
– 1 AC: 200 V ... 240 V ±10 %
– 3 AC: 200 V ... 240 V ±10 %
– 3 AC: 380 V ... 480 V ±10 %
● For PM240-2 FSD, FSE and FSF Power Modules, blocksize format:
– 3 AC: 200 V ... 240 V ±10 % (in operation -20 % < 1 min)
– 3 AC: 380 V ... 480 V ±10 % (in operation -20 % < 1 min)
– 3 AC: 500 V ... 690 V ±10 % (in operation -20 % < 1 min)
● For PM240-2 FSG blocksize Power Modules:
– 3 AC: 380 V ... 480 V ±10 % (in operation -20 % < 1 min)
– 3 AC: 500 V ... 690 V ±10 % (in operation -20 % < 1 min)
● For Power Modules, chassis format:
– 3 AC: 380 V... 480 V ± 10 %
The following line reactor variants are available:
● 4 versions for chassis format
● 5 versions for chassis format
The following line filter variants are available:
● Integrated versions for the blocksize format to comply with EMC category C2 or C3
● External versions for the chassis format to comply with EMC category C2 or C3
AC Drive
Manual, 06/2019, 6SL3097-5AL00-0BP1
4
45