Drive-Cliq Signal Cables Motion-Connect With Drive-Cliq Connectors; Motion-Connect Drive-Cliq Signal Cables With Drive-Cliq Connector And M12; Socket - Siemens S120 Manual

10.6.1.3

DRIVE-CLiQ signal cables MOTION-CONNECT with DRIVE-CLiQ connectors

The MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connectors have 24
V DC cores. They are used for components with DRIVE-CLiQ connection if higher
requirements must be complied with, such as mechanical stress and resistance to oil. For
example, the signal cables are used for connections outside the control cabinet
The maximum length of the DRIVE-CLiQ MOTION-CONNECT signal cables with DRIVE-
CLiQ connectors is:
● 100 m for MOTION-CONNECT 500 cables
● 75 m for MOTION-CONNECT 800PLUS cables
The signal cables are available in degrees of protection IP20 and IP67.
Note
DRIVE-CLiQ cabinet bushing for DRIVE-CLiQ connectors
For information about the cabinet bushing, see DRIVE-CLiQ cabinet bushing (Page 391).
10.6.1.4

MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12

socket

The MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12
socket have 24 V DC cores. They establish the connection between components with a
DRIVE-CLiQ connection and a direct measuring system equipped with DRIVE-CLiQ ASIC
with 8-pin M12 connector. Measuring systems from third-party manufacturers can be directly
connected to the SINAMICS S120.
Basic cable
The pre-assembled basic cable has eight cores, of which four are used for data transmission
and two for the 24 V supply. It is used to convert from a DRIVE-CLiQ connector (IP20) to an
M12 socket (IP67).
Figure 10-3
AC Drive
Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
Cabinet design and EMC for components, Blocksize format
DRIVE-CLiQ basic cable with DRIVE-CLiQ connector and M12 socket
10.6 Connection Methods
429