Warning Messages - KEB COMBIVERT R6-S Applications Manual

Display COMBIVIS
E.SEt Error ! Set
E.SYn Error! Synchronization
E. UP Error ! Undervoltage

Warning Messages

A.buS Warning ! Watchdog
Warning ! ERROR external
A. EF
fault
no ABN.STOP Power module
A.nOH
temperature
no ABN.STOP Interior
A.nOHI
temperature
A.nOL no ABN.STOP Overload
Warning ! Power module
A. OH
temperature
Warning ! Interior
A.OHI
temperature
A. OL Warning ! Overload
A.SEt Warning ! Set
© KEB, 2008-02
Value Meaning
It has been attempted to select a locked parameter set. Programmed
39
response "Error, restart after reset".
59 Phase allocation at commutation choke not correct.
Error: Undervoltage (DC-link circuit). Occurs, if DC-link voltage falls
below the permissible value. Causes:
-
2
-
-
Watchdog for communication between operator / PC or operator
93 / inverter has responded. The response to this warning can be
programmed.
This warning is triggered via an external input. The response to this
90
warning can be programmed.
88 The heat sink temperature is again below the adjusted warning level.
The temperature in the interior of the inverter is again below the
92
warning threshold.
Warning: no more overload, OL counter has reached 0 %, warning
98
„overload" can be reset.
A level can be defined, when it is exceeded this warning is output.
89
Furthermore the response to this warning can be programmed.
The temperature in the interior of the inverter lies above the permissible
87 level. The switch off time was started. The programmed response to
this warning message is executed.
A level between 0 and 100% of the load counter can be adjusted, when
99 it is exceeded this warning is output. The response to this warning can
be programmed.
It has been attempted to select a locked parameter set. The response
102
to this warning can be programmed.
COMBIVERT R6-S
input voltage too low or unstable
Transformer capacity too small
voltage losses through wrong cabling
Error assistance
5
Page 5.1 - 5