KEB COMBIVERT R6-S Applications Manual page 52

Operating and appliance data
Parameter
ru.23 Output condition state
With parameters do 00...do.07 switching conditions can be selected, that serve as base for setting the out-
puts. This parameter indicates which of the selected switching conditions are met before they are linked or
inverted by programmable logic (also see chapt. 3.3. „Digital outputs"). According to following table a speci-
fic decimal value is given out for the switching conditions. If several of the selected switching conditions are
met, the sum of the decimal values is indicated.
Parameter
ru.24 State of output flags
Display of the output flags after logic step 1. The selected switching conditions are linked in logic step 1
(do.8...24) and indicated here (see chapt. 3.3 „Digital outputs"). According to following table a specific deci-
mal value is given out for any output flags. If several output flags are set, the sum of the decimal values is
indicated.
Page 3.2 - 8 COMBIVERT R6-S
Addr.
0217h
Bit Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
Addr.
0218h
Bit Decimal value
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
R PG E Min. value
ro - -
Output
switching condition 0 (do.00)
Switching condition 1 (do.01)
Switching condition 2 (do.02)
Switching condition 3 (do.03)
Switching condition 4 (do.04)
Switching condition 5 (do.05)
Switching condition 6 (do.06)
Switching condition 7 (do.07)
R PG E Min. value
ro - -
Output
Flag 0
Flag 1
Flag 2
Flag 3
Flag 4
Flag 5
Flag 6
Flag 7
Max. value Res.
0 255
Max. value Res.
0 255
© KEB, 2008-02
[?] Default
1 - -
[?] Default
1 - -