KEB COMBIVERT R6-S Applications Manual page 124

Define CP-Parameters
3.9.2 Assignment of the CP-Parameters
CP selector (ud.15)
The CP-Parameter to be programmed in a range of 1...36 is adjusted with ud.15. CP.00 is not adjustable.
CP address (ud.16)
ud.16 determines the parameter address of the parameter to be displayed:
ud.16: CP address
0...32767: Parameter address
CP Set norm (ud.17)
The set, the addressing and the norm of the parameter to be displayed are specified with ud.17. The parameter
is bit-coded. The individual bits are decoded as follows:
Define set selection for direct set addressing
Bit 0...7 determine the set selection for direct set programming i.e., all selected sets gets the same value, deter-
mined by the CP-Parameter. If direct set programming (bit 8, 9) is selected, at least one set must be selected,
otherwise error message "set invalid" is displayed in the CP menue.
7 6 5
0 0 0
0 0 0
0 0 0
0 0 0
1 1 1
Define set addressing mode
Bit 8 and 9 determine the set addressing mode:
Bit
8 9 Value Function
0 0
0 1 256
1 0 512
1 1 768
Page 3.9 - 4
-1: Parameter not used
Bit
4 3 2 1
0 0 0 0
0 0 0 0
0 0 0 1
0 0 1 0
...
1 1 1 1
0 direct set addressing; the defined sets of bit 7 .. 0 are valid
actual set; the actual set is displayed / edited
indirect set addressing, the parameter set determined by the set pointer Fr.09
is displayed / edited
reserved
COMBIVERT R6-S
Not available or not allowed pa-
rameter addresses are rejected
with "data invalid".
0 Value Set
0 0 no
1 1 0
0 2 1
0 3 0+1
... ...
1 255 All
-> Data invalid, if bit 8 + 9 = 0
© KEB, 2008-02