KEB COMBIVERT R6-S Applications Manual page 69

3.3.5 Amplifier of the output characteristic (An.33...35 / An.43...45 / An.49...51)
As shown in picture 7.2.1, the characteristic amplifiers follow after the selection of the output signal. With the-
se parameters the output signal can be adapted in x and Y direction and in the slope to the requirements. No
zero offset is adjusted at factory setting, the amplification is 1, i.e., 100% of the output size correspond to 10V
at the analog output (see picture 7.2.2).
Function
Amplification
X-Offset
Y-Offset
Picture 7.2.5.a factory setting: no offset, gain 1
Invert the analog output
An example for the use of the characteristic amplifier is shown in picture 7.2.5.b
1. set X-Offset (An.34) to 100 (%)
2. set the gain (An.33) to -1.00
Picture 7.2.5.b Invert the analog output
-100%
-100%
This adjustments cause an inversion of the analog signal.
0% corresponds to 10V
100% corresponds to 0V
© KEB, 2008-02
ANOUT1 Value range
An.33 ±20,00
An.34 ±100,0%
An.35 ±100,0%
Output voltage
100%
-100%
An.34
-100%
An.35
An.35
100% 10V
An.33
An.34
100%
at the output
at the output
COMBIVERT R6-S
Resolution Default
0,01 1,00
0,1% 0,0%
0,1% 0,0%
visible
10V
range
variable to be indicated
An.33
100%
Analog outputs
Page 3.3 - 5
3
10