Fic/Dfic; Ethernet Switching Module; Fic-16Fsw/Fic-16Fswp/Dfic-24Fsw/Dfic-24Fswp - H3C MSR Router Comware 5 Series Manual

FIC/DFIC

H3C MSR router series uses modular design and supports a wide range of flexible interface modules
(FICs) and double flexible interface modules (DFICs). These interface modules provide abundant
interfaces, including synchronous/asynchronous serial interface, Ethernet interface, E1/T1, ISDN
BRI/PRI, audio interface, and Layer 2 switching interface.
Among these FIC/DFIC interface modules, Ethernet switching modules FIC-16FSWP and
DFIC-24FSWP are PoE-capable. When installed on a PoE router, they can provide –48 VDC power
to remote PDs (such as IP phone, WLAN AP, and network camera) through straight-through network
cables.

Ethernet switching module

•
FIC-16FSW
•
FIC-16FSWP
•
DFIC-24FSW
•
DFIC-24FSWP

FIC-16FSW/FIC-16FSWP/DFIC-24FSW/DFIC-24FSWP

Introduction
The 16/24-port
(FIC-16FSW/FIC-16FSWP/DFIC-24FSW/DFIC-24FSWP) are used on H3C MSR 50 routers. A
router installed with FIC-16FSW/FIC-16FSWP/DFIC-24FSW/DFIC-24FSWP modules can work as a
switching/routing integrated device on a small-sized enterprise network to connect PCs and network
devices inside the network.
A FIC-16FSW/FIC-16FSWP interface module provides the following interfaces:
•
16 × 10/100 Mbps RJ-45 ports
•
1 × 10/100/1000 Mbps RJ-45 copper port
•
1 × SFP fiber port (fiber ports and GE copper ports share the MAC layer)
A DFIC-24FSW/DFIC-24FSWP interface module provides the following interfaces:
•
24 × 10/100 Mbps RJ-45 ports
•
2 × 10/100/1000 Mbps RJ-45 copper ports
•
2 × SFP fiber ports (fiber ports and GE copper ports share the MAC layer). By default, the
copper ports take effect.
The modules support:
10/100 Mbps Ethernet Layer 2 switching
98
MIM interface modules