H3C MSR Router Comware 5 Series Manual page 60

•
Autosensing at a rate of 10/100/1000 Mbps of the two GE interfaces.
•
Autosensing at a rate of 10/100 Mbps of the 46 FE interfaces.
•
Full duplex and half duplex, of which full duplex is common.
Interface specifications
Table 68 Interface specifications
Item
Connector type
Interface type
Number of connectors
Cable type
Operation mode
NOTE:
Ethernet interfaces on network adapters are usually medium dependent interfaces (MDIs). Medium
dependent interface crossover (MDIX) is another type of Ethernet interface, which is usually used on
hubs and LAN switches.
Interface LEDs
Figure 53 DMIM-48FSW panel
Each 10/100 Mbps Ethernet interface on the panel has one green LED.
Table 69 LED description for the DMIM-48FSW FE port
LED status
Steady green
Off
Flashing green
Table 70 LED description for the DMIM-48FSW GE port
LED status
Steady green
Off
Flashing green
Description
RJ-45
MDI/MDIX
46 × 100 Mbps RJ-45 connectors
2 × 1000 Mbps RJ-45 connectors
Standard (straight-through) Ethernet cable/crossover Ethernet cable
Forty-six 100 Mbps interfaces: Autosensing 10/100 Mbps, full duplex/half duplex
Two 1000 Mbps copper ports: Autosensing 10/100/1000 Mbps
Description
A 100 Mbps connection is established, and no data is being transmitted or received.
No link is present on the port.
A 100 Mbps connection is established, and data is being transmitted or received.
Description
A 1000 Mbps connection is established, and no data is being transmitted or
received.
No link is present on the port.
A 1000 Mbps connection is established, and data is being transmitted or received.
51
Table 69 describes the LED.