Page 1
H3C PSR1600B-12A-B Power Module User Manual New H3C Technologies Co., Ltd. http://www.h3c.com Document version: APW100-20190612...
Page 2
All rights reserved No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of New H3C Technologies Co., Ltd. Trademarks Except for the trademarks of New H3C Technologies Co., Ltd., any trademarks that may be mentioned in this document are the property of their respective owners.
Overview About the power module The PSR1600B-12A-B is an AC-input and DC-output power module. It provides a maximum output of 1600 W. The power module has the following features: • Self-protection—The power module provides a self-protection mechanism against input overcurrent, input undervoltage, output overcurrent, output overvoltage, output short circuit, and overtemperature conditions.
Item Specification Ambient temperature, –10°C to +55°C (+14°F to +131°F) operating Ambient humidity (RH), 5% to 95% noncondensing Views Figure 1 PSR1600B-12A-B power module view (1) Handle (2) AC-input receptacle (3) Latch (4) Status LED LEDs...
Page 6
The power module has a LED to indicate its operating status. LED status Description The power module is operating correctly, Steady green and is in active state. Flashing green at The power module is operating correctly, 1 Hz and is in standby state. Flashing green at The power module is updating the software.
• To avoid power module damage, do not open the power module. When an internal circuit or component is faulty, contact H3C Support. Installation tools You must wear an ESD wrist strap when installing or removing the power module.
Page 8
Figure 2 Power module installation procedure To install the power module: Wear an ESD wrist strap, and make sure the strap makes good skin contact and is reliably grounded. Unpack the power module. Make sure the power module model is as required. As shown in Figure 3, correctly orient the power module.
Figure 3 Installing the power module IMPORTANT: Keep safe the filler panel for the power module slot and the package for the power module. Connecting the power cord WARNING! • Make sure each power cord has a separate circuit breaker. •...
Page 10
Figure 4 Connecting the AC power cord As shown in Figure 5, use a cable tie to secure the power cord to the handle of the power module. Figure 5 Securing the AC power cord Connect the other end of the power cord to an external AC power source and turn on the circuit breaker.
If the LED is steady green or flashing green, the power cord is connected correctly. If the LED is off or amber, check the installation and fix the issues. Removing the power module To avoid bodily injury or device damage, strictly follow the procedure Figure 6 to remove the power module.
Page 12
Figure 7 Removing the power module Place the removed power module on an anti-static mat or put it into its original package. If you are not to install a new power module, install a filler panel in the slot to prevent dust and ensure good ventilation in the device.
Need help?
Do you have a question about the PSR1600B-12A-B and is the answer not in the manual?
Questions and answers