H3C MSR Router Comware 5 Series Manual page 45

Item
Cable type
Rates
Services
Interface LEDs
Figure 40 SIC-3G-GSM panel
Table 51 LED description
LED
WWAN
RSSI
UMTS
HSDPA
Antennas, interface cables, and the connection methods
For more information about antennas, interface cables, and the connection methods for the
SIC-3G-GSM interface module, see
Installing a SIM module
CAUTION:
Make sure the beveled corner of the SIM module fits into the beveled corner of the SIM socket.
To install a SIM module:
Open the SIM module socket in the direction marked OPEN so the holder projects upwards.
1.
Insert the SIM module into the SIM module socket along the guide rails.
2.
Close the SIM module socket in the direction marked LOCK to lock the card in position.
3.
Execute the display cellular [ interface-number ] command after the router is started. When
4.
"SIM Status = OK" appears in the output information, the SIM module is identified.
Description
TNC RF: None
RJ-45: AUX cable
•
HSDPA (downlink: 7.2 Mbps)
•
HSUPA (uplink: 5.76 Mbps)
•
UMTS (downlink: 384 Mbps, uplink: 384 Kbps)
•
EDGE (downlink: 236.8 Kbps, uplink: 236.8 Kbps)
•
GPRS (downlink: 85.6 Kbps, uplink: 85.6 Kbps)
GPRS/EDGE/UMTS/HSDPA
Description
•
Steady green: A link is present.
•
Flashing green: Data is being transmitted or received.
•
Steady green: Strong signal.
•
Flashing green: Middle or low signal.
•
Off: Weak signal or no signal.
•
Steady yellow: The service is valid.
•
Off: No service.
•
Steady yellow: The service is valid.
•
Off: No service.
"3G interface."
36