Interface specifications
Table 16 Interface specifications
Item
Connector type
Number of connectors
Interface standard
Interface rate
Cable type
Operating mode
Supported service
Interface LEDs
Figure 12 SIC-1EPRI panel
Table 17 LED description
LED
LINK/ACT
LP/AL
Interface cables and the connection methods
For more information about E1 interface cables and the connection methods, see
Description
D15
1
•
G.703
•
G.704
2.048 Mbps
•
75-ohm unbalanced coaxial cable (D15 to BNC)
•
Coaxial connector, network interface connector, and 75-ohm to 120-ohm
adapter
NOTE:
The default resister for the interface on the SIC-1EPRI is 75 ohm. A 75-ohm to
120-ohm adapter must be used when a 120-ohm cable is connected to the
SIC-1EPRI.
•
E1
•
CE1
•
ISDN PRI
•
Backup
•
Terminal access
•
ISDN
Description
•
On: Carrier signals are received.
•
Flashing: Data is being transmitted or received.
•
Off: No carrier signals are received.
•
On: The interface is in a loopback.
•
Flashing: An alarm indication signal (AIS), loss of frame alignment (LFA)
signal, or remote alarm indication (RAI) signal is present.
•
Off: Neither loopback nor alarm is present.
11
"E1
interface."