H3C MSR Router Comware 5 Series Manual page 15

NOTE:
SIC-1GEC-V2/SIC-1GEC-H3 provides combo interfaces. The fiber and copper ports of a combo
interface cannot be used simultaneously. By default, the copper port is available. To use the fiber
port, execute the related command.
Interface LEDs
Figure 7 SIC-1GEC-H3 panel
Figure 8 SIC-1GEC-V2 panel
Table 8 LED description for the copper port on the SIC-1GEC-V2/SIC-1GEC-H3 panel
LED
LINK
ACT
Table 9 LED description for the fiber port on the SIC-1GEC-V2/SIC-1GEC-H3 panel
LED
LINK
ACT
Interface cables and the connection methods
For more information about Ethernet interface cables and the connection methods, see
interface."
For more information about transceiver modules, optical fibers, and the connection methods, see
"Fiber port."
Description
•
On: Carrier signal is received;
•
Off: No carrier signal is received;
•
Green: Data is being received and transmitted at a speed of 1000 Mbps.
•
Yellow: Data is being received and transmitted at a speed of 100/10 Mbps.
•
Off: No data is being received and transmitted;
•
Flashing: Data is being received and transmitted.
Description
•
On: Carrier signal is received;
•
Off: No carrier signal is received;
•
Green: Data is being received and transmitted at a speed of 1000 Mbps;
•
Yellow: Fault.
•
Off: No data is being received and transmitted;
•
Flashing: Data is being received and transmitted.
6
"Ethernet