Table of Contents
Advertisement
R
T
J
A
EINSTALLING
HE
ACK
ND
1. Tighten the jack all the way down by
turning the jack turn-screw counter-
clockwise until the jack is snug.
2. Position the jack and tool bag. Make sure
the lug wrench is under the jack near the
jack turn-screw.
Jack And Tool Bag
3. Secure the tool bag straps to the jack.
4. Place the jack and tools in the storage
position holding the jack by the jack
turn-screw, place the jack and tools under
the rear seat.
T
5. Turn the wing bolt clockwise to secure to the
OOLS
floor pan.
Jack Hold Down Wing Bolt
After using the jack and tools, always reinstall
them in the original carrier and location.
While driving you may experience abrupt
stopping, rapid acceleration or sharp turns. A
loose jack, tools or bracket or other objects in
the vehicle may move around with force,
resulting in serious injury.
WARNING!
IN CASE OF EMERGENCY
JUMP STARTING
If your vehicle has a discharged battery, it can
be jump started using a set of jumper cables
and a battery in another vehicle, or by using a
portable battery booster pack. Jump starting
can be dangerous if done improperly, so please
follow the procedures in this section carefully.
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system
voltage greater than 12 Volts or damage to
the battery, starter motor, alternator or
electrical system may occur.
NOTE:
When using a portable battery booster pack,
follow the manufacturer's operating instruc-
tions and precautions.
301
6
Advertisement
Table of Contents
