6.7 Switching Operation Modes
6.7.3 Switching between REM (Remote) and LCL (Local)
Setting Display
Setting Details
Description
6-26
Operation Mode Setting Display
Parameter
Name
symbol
REMOTE/LOCAL
R.L
switch
REMOTE/LOCAL switching can be performed by any of the following:
(1) Contact input (status or edge)
(2) Parameter
(3) Communication
(4) User function key
REMOTE
LOCAL
When the contact input (status) is ON, operation cannot be performed by parameter,
communication, or keystroke.
When the contact input is OFF, and the setting is switched by parameter, communication,
or keystroke, the last switching operation is performed.
The last switching operation is performed for all methods, when the action of contact
input is detected as rising edge.
► Switch by contact input: 12.1 Setting Contact Input Function
► Switch by user function key: 13.2 Assigning Function to User Function Key and A/M key
The PID group before switching from LOCAL to REMOTE is applied to the PID in remote
operation.
Operation Display > PARAMETER or PARA key for 3
seconds (to [MODE] Menu Display) > SET/ENTER key
(The operation mode is displayed.) > Down arrow key (The
operation mode is displayed.)
The parameter R.L is displayed when the the communication
is specified.
Display
Setting range
level
LCL: Local mode
EASY
REM: Remote mode
Menu symbol
MODE
IM 05P01D31-01EN
Need help?
Do you have a question about the UT Advanced UT32A and is the answer not in the manual?