Input Connections; Output Connections - Extron electronics StudioStation 100 Setup Manual

StudioStation 100 • Setup Guide (Continued)
F Remote — To control the StudioStation 100 using SIS commands over RS-232, connect the host RS-232 cable to
the rear panel (see the illustration at right) with a 3-pole captive screw connector for bidirectional serial host control
(see figure 1 on the previous page).
The default protocol for this port:
• 9600 baud •
Remote control port — Connect the StudioStation 100 with the RCP 101 EU/MK or decorator-style wallplate using
G
a female type A USB connector. The RCP 101 has a USB Storage port, which provides an additional recording
location.
12V external power output — Connect the RCP 101 to the StudioStation 100 using a 2-pin, blue captive screw
H
connector. The 12V power is required to power an RCP 101 remote control.
I Reset button and LED — The StudioStation 100 has several reset modes to return user-defined configuration
settings or all settings back to factory defaults. The LED blinks to indicate the desired reset mode, and provides the
reset status during the reset operation. For information on selecting the reset mode, see the StudioStation 100 User Guide at
www.extron.com.
RJ-45 Ethernet LAN port — Use a standard Ethernet cable to connect to a network. The
J
table at right has the default network settings.

Input Connections

HDMI input – Connect an HDMI (or DVI with a suitable adapter) source device to the input.
C
Analog audio input – Connect a balanced or unbalanced stereo line level audio device to this 5-pole 3.5 mm captive screw
D
input. Wire the connector as shown in figure 2.
Tip
Ring
Sleeve(s)
Tip
Ring
Balanced Stereo Input
(high impedance)
Audio Input Captive Screw Connector Wiring
Figure 2.
ATTENTION:
• The length of the exposed wires in the stripping process is important. The ideal length is 3/16 inch (5 mm). If
longer, the exposed wires may touch, causing a short circuit between them. If shorter, the wires can be easily
pulled out even if tightly fastened by the captive screws.
• La longueur des câbles exposés est primordiale lorsque l'on entreprend de les dénuder. La longueur idéale est de
5 mm (3/16 inches). S'ils sont un peu plus longs, les câbles exposés pourraient se toucher et provoquer un court
circuit. S'ils sont un peu plus courts, ils pourraient sortir, même s'ils sont attachés par les vis captives.
• Do not tin the wires. Tinned wires are not as secure in the captive screw connector and could pull out.
• Ne pas étamer les câbles. Les câbles étamés ne sont pas aussi bien fixés dans les connecteurs des à vis captives
et pourraient sortir.

Output Connections

HDMI preview output – Connect an HDMI (or DVI with a suitable adapter) display device to this HDMI output
E
(see figure 1 on page 1). The preview output switches between the record preview content and the internal browser using
an attached USB keyboard and mouse (optional), which can be connected to either the front panel or rear panel USB ports.
2
no parity • 8 data bits
Tip
Left
Sleeve
Tip
Right
Sleeve
• 1 stop bit • no flow control (handshaking)
Left
Right
Unbalanced Stereo Input
(high impedance)
IP Address: 192.168.254.253
Subnet Mask: 255.255.0.0
Default Gateway: 0.0.0.0
DHCP: OFF
Do not tin the wires!
REMOTE
RS-232
Tx Rx G