Torque Current Limitation [95] - WEG CFW-11 Programming Manual

Vector Control
P0413 – t constant (Mechanical time constant)
m
Adjustable
Range:
Proprieties:
Access groups
via HMI:
Description:
The P0413 setting determines the speed regulator gains (P0161 and P0162).
When P0408=1 or 2, it must be observed:
If P0413=0, the time constant T
(table value);
If P0413>0, the value of P0413 will not be changed by the self-tuning.
Sensorless vector control (P0202=3):
When the P0413 value obtained through the self-tuning provides inadequate speed regulator gains (P0161
and P0162), it is possible to change them by setting P0413 via keypad (HMI);
The P0161 gain provided by the self-tuning or through P0413 change, will be limited to the range:
6.0≤P0161≤9.0;
The P0162 value varies in function of the P0161 value;
In case it be necessary to increase even more these gains, they must be adjusted directly at P0161 and
P0162.
Note: Values of P0161>12.0 may turn the torque current (I
Vector control with encoder (P0202=4):
The P0413 value is estimated by the self-tuning when P0408=3 or 4.
The measurement procedure consists in accelerating the motor up to 50% of the rated speed, applying a current
step equal to the motor rated current.
In case that it is not possible to submit the load to this type of request, adjust P0413 via keypad (HMI), refer to the
section 11.8.1.

11.8.6 torque current Limitation [95]

The parameters placed in this group define the torque limitation values.
P0169 – Maximum forward torque current
P0170 – Maximum Reverse torque current
Adjustable
11
Range:
Proprieties:
Access groups
via HMI:
11-26
0.00 to 99.99 s
Vector
01 PARAMETER GROUPS
29 Vector Control
94 Self-tuning
will be obtained in function of the inertia of the programmed motor
m
0.0 to 650.0 %
Vector
01 PARAMETER GROUPS
29 Vector Control
95 Torque Curr.Limit
05 SELF-TUNING
or
) and the motor speed unstable (oscillating).
q
Factory 0.00 s
Setting:
Factory 125.0 %
Setting: