Local Command [31]; Remote Command [32] - WEG CFW-11 Programming Manual

Digital and Analog Inputs and Outputs

13.2 LocaL coMMaND [31]

13.3 ReMote coMMaND [32]

In those parameter groups one can configure the origin of the main inverter commands when in the LOCAL or
in the REMOTE situation, as the Speed Reference, Speed Direction, Run/Stop and JOG.
P0220 – LocaL/ReMote Selection Source
Adjustable
Range:
Proprieties:
Access groups
via HMI:
Description:
It defines the origin of the command that will select between the LOCAL situation and the REMOTE situation,
where:
LOCAL: Means Local Default situation.
REMOTE: Means Remote Default situation.
DIx: Refer to the section 13.1.3.
P0221 – Speed Reference Selection – LocaL Situation
P0222 – Speed Reference Selection – ReMote Situation
Adjustable
Range:
13
13-28
0 = Always LOCAL
1 = Always REMOTE
2 = Local/Remote Key LOCAL
3 = Local/Remote Key REMOTE
4 = DIx
5 = Serial/USB LOCAL
6 = Serial/USB REMOTE
7 = Anybus-CC LOCAL
8 = Anybus-CC REMOTE
9 = CANopen/DeviceNet LOCAL
10 = CANopen/DeviceNet REMOTE
11 = SoftPLC LOCAL
12 = SoftPLC REMOTE
13 = PLC11 LOCAL
14 = PLC11 REMOTE
CFG
01 PARAMETER GROUPS
31 Local Command
0 = Keypad
1 = AI1
2 = AI2
3 = AI3
4 = AI4
5 = AI1 + AI2 > 0 (Sum AIs > 0)
6 = AI1 + AI2 (Sum AIs)
7 = E.P .
8 = Multispeed
9 = Serial/USB
10 = Anybus-CC
11 = CANopen/DeviceNet
12 = SoftPLC
13 = PLC11
Factory
Setting:
or 01 PARAMETER GROUPS
32 Remote Command
Factory
Setting:
2
P0221=0
P0222=1