WEG CFW-11 Programming Manual page 189

Proprieties: CFG
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
They define the origin of the Speed Reference in the LOCAL situation and in the REMOTE situation.
Some notes about the options for those parameters:
The AIx' designation refers to the analog signal obtained after the addition of the AIx input to the offset and its
multiplication by the applied gain (refer to the section 13.1.1).
The value of the reference adjusted with the
When the option 7 is selected (E.P .), one of the digital inputs must be programmed at 11 (Increase E.P .) and
another at 12 (Decrease E.P .). Refer to the section 12.5 for more details.
When the option 8 is selected, P0266 and/or P0267 and/or P0268 must be programmed at 13 (Multispeed).
Refer to the section 12.4.
When P0203=1 (PID Regulator), do not use the reference via E.P .
When P0203=1, the value programmed in P0221/P022 becomes the PID Setpoint.
P0223 – foRWaRD/ReVeRSe Selection - LocaL Situation
P0226 – foRWaRD/ReVeRSe Selection - ReMote Situation
Adjustable 0 = Always FORWARD
Range: 1 = Always REVERSE
2 = Forward/Reverse Key (FWD)
3 = Forward/Reverse Key (REV)
4 = DIx
5 = Serial/USB (FWD)
6 = Serial/USB (REV)
7 = Anybus-CC (FWD)
8 = Anybus-CC (REV)
9 = CANopen/DeviceNet (FWD)
10 = CANopen/DeviceNet (REV)
11 = AI4 Polarity
12 = SoftPLC (FWD)
13 = SoftPLC (REV)
14 = AI2 Polarity
15 = PLC11 FORWARD
16 = PLC11 REVERSE
Proprieties: CFG
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
They define the origin of the "Speed Direction" command in the LOCAL situation and in the REMOTE situation,
where:
FWD: Means Forward Default situation.
REV: Means Reverse Default situation.
DIx: Refer to the section 13.1.3.
31 Local Command
and
31 Local Command
Digital and Analog Inputs and Outputs
or 01 PARAMETER GROUPS
32 Local Command
is contained in the parameter P0121.
Factory
Setting:
or 01 PARAMETER GROUPS
32 Remote Command
P0223=2
P0226=4
13
13-29