WEG CFW-11 Programming Manual page 134

Vector Control
Seq. Action/Result
- Monitoring Mode.
- Press "Menu"
(right "soft key").
1
- The group "00 ALL
PARAMETERS" is already
selected.
2
- The group "01
PARAMETER GROUPS" is
selected.
3
- The group "02 ORIENTED
START-UP" is then selected.
- Press "Select".
4
- The parameter
"Oriented Start-up
P0317: No" is already
5
selected.
- Press "Select".
- The content of "P0317 =
[000] No" is showed.
6
- The content of the
parameter is changed to
"P0317 = [001] Yes"
7
- Press "Save".
11
11-32
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
13:48 Menu
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 13:48 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 13:48 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 13:48 Select
Ready LOC 0rpm
Oriented Start-up
P0317: No
Return 13:48 Select
Ready 0rpm
LOC
P0317
Oriented Start-up
[000] No
Return 13:48 Save
Ready LOC 0rpm
P0317
Oriented Start-up
[001] Yes
Return 13:48 Save
Figure 11.6 - Vector mode Oriented Start-up
Seq. Action/Result
- In this moment the
Oriented Start-up routine is
initiated and the "Config"
status is indicated at the top
left part of the keypad (HMI).
- The parameter "Language
P0201: English" is already
selected.
8
- If necessary, change
the language by pressing
"Select", next
and
to select the language and
then press "Save".
- Set the content of P0202
pressing "Select".
until
-Next press
selecting the option "[003]
Sensorless or [004]
Encoder". This change resets
the contents of P0410. Then
press "Save".
- Note that from this moment
9
on the option "Reset" (left
"soft key") or are no
longer available.
-There are 3 options to leave
the Oriented Start-up:
1.Executing the Self-Tuning;
2.Setting the parameters
P0409 to P0413
manually;
3.Changing P0202 from
vector to scalar control.
Display Indication
Config 0rpm
LOC
Language
P0201: English
Type of Control
P0202: V/F 60Hz
Reset 13:48 Select
Config 0rpm
LOC
Language
P0201: English
Type of Control
P0202: V/F 60Hz
Reset 13:48 Select