WEG CFW-11 Programming Manual page 237

Notes:
- If P0552=6 and no DI is configured for "Trace Function", the trigger will not occur;
- If P0552=6 and several DIs were configured for "Trace Function", only one has to be active for the trigger
occurrence;
- If P0552≠6 and any DI is configured for "Trace Function", the trigger will never occur as a result of the DI
activation;
- These three programming options do not prevent the inverter from being enabled.
P0553 – trace Sampling Period
Adjustable 1 to 65535
Range:
Proprieties:
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
It defines the sampling period (time between two sampling points) as a 200 µs multiple.
For P0297=1.25 kHz, it defines the sampling period as a 400 µs multiple
P0554 – trace Pre-trigger
Adjustable 0 to 100 %
Range:
Proprieties:
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
It is the data percentage that will be recorded before the occurrence of the trigger event.
P0559 – trace Maximum Memory
Adjustable 0 to 100 %
Range:
Proprieties:
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
It defines the maximum of memory that the user wished to reserve for the Trace Function points. The setting range,
from 0 to 100 %, corresponds to a reserve request of 0 to 15 KB for the Trace Function.
Each point stored by the Trace Function takes 2 bytes of memory. This parameter defines indirectly the number of
points that the user wishes to store with the Trace Function.
52 Trace Function
52 Trace Function
52 Trace Function
Trace Function [52]
Factory 1
Setting:
Factory 0 %
Setting:
Factory 0 %
Setting:
19-3
19