A Parameter Cannot Be Changed - Siemens SINAMICS G120 Operating Instructions Manual

Entering the parameter value directly
The BOP-2 offers the option of setting the parameter value digit by digit.
Precondition
The parameter value flashes in the BOP-2 display.
Procedure
To select the parameter value directly, proceed as follows:
1. Press the OK button for longer than five seconds.
2. Change the parameter value digit-by-digit.
If you press the OK button then the BOP-2 jumps to the
next digit.
3. If you have entered all of the digits of the parameter
value, press the OK button.
You have now entered the parameter value directly.
A.3.4

A parameter cannot be changed

When must you not change a parameter?
The converter indicates why it currently does not permit a parameter to be changed:
You have attempted to change
The operating state in which you can change a parameter is provided in the List Manual for
each parameter.
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
a read-only parameter.
A.3 Handling the BOP 2 operator panel
You must change to basic
commissioning to set this pa-
rameter.
Appendix
You must turn the motor off to
set this parameter.
443