Entering the parameter value directly
The BOP-2 offers the option of setting the parameter value digit by digit.
Precondition
The parameter value flashes in the BOP-2 display.
Procedure
To select the parameter value directly, proceed as follows:
1. Press the OK button for longer than five seconds.
2. Change the parameter value digit-by-digit.
If you press the OK button then the BOP-2 jumps to the next digit.
3. If you have entered all of the digits of the parameter value, press the
OK button.
You have now entered the parameter value directly.
A.3.4
A parameter cannot be changed
When must you not change a parameter?
The converter indicates why it currently does not permit a parameter to be changed:
You have attempted to change
The operating state in which you can change a parameter is provided in the List Manual for
each parameter.
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
a read-only parameter.
A.3 Handling the BOP 2 operator panel
You must change to quick
commissioning to set this pa-
rameter.
Appendix
You must turn the motor off to
set this parameter.
491