Amount The Shield Plate Onto The Power Module - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
4.2.3
Amount the shield plate onto the Power Module
Shielding with shield plate:
Connect the cable shields to the shield plate through the largest possible surface area using
shield clamps.
Depending on the particular Power Module, the shield plate is included in the scope of
delivery, or is optionally available as shield connection kit. You can find additional
information in Catalogs D11.1 and D35).
Shielding without shield plate:
● EMC-compliant shielding can also be implemented without using a shield plate. In this
case, you must ensure that the cable shields are connected to the ground potential
through the largest possible surface area.
Mounting the shield plate, PM230
Figure 4-1
Figure 4-2
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Mounting the shield plate, FSA ... FSC
Mounting the shield plate, FSD ... PSF
4.2 Connecting inverters in compliance with EMC
Installing
51
Advertisement
Table of Contents
