Installing Reactors, Filters And Braking Resistors - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Installing
4.3 Installing reactors, filters and braking resistors
4.3
Installing reactors, filters and braking resistors
Installing reactors, filters and braking resistors
The following supplementary components may be required depending on the Power
Modules and the particular application:
● Line reactors
● Filter
● Braking resistors
● Brake Relay
Installing these components is described in the documentation provided. See also Section:
Manuals and technical support (Page 451).
Installing a base component
Reactors, filters and braking resistors are available as base components for the PM240 and
PM250 Power Modules, frame sizes FSA, FSB and FSC. You can also install base
components next to Power Modules.
Figure 4-6
54
Available base components
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Advertisement
Table of Contents
