General Data, Pm250 - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
10.2.4.1
General data, PM250
Property
Line voltage
Output voltage
Input frequency
Power factor λ
Inrush current
Pulse frequency (factory
setting)
Electromagnetic compatibil-
ity
Braking methods
Degree of protection
Operating temperature at
Storage temperature
Relative humidity
Pollution
Environmental requirements Protected against damaging chemical substances according to environmental class 3C2 to
Shock and vibration
Installation altitude
Standards
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Version
380 V ... 480 V 3-ph. AC ± 10 %
0 V 3-ph. AC ... input voltage x 0.87 (max.)
47 Hz ... 63 Hz
0.9
< LO base load input current
4 kHz
The pulse frequency can be adjusted up to 16 kHz in 2 kHz steps. The higher the pulse
frequency, the lower the available output current. For details, see Restrictions for special
ambient conditions (Page 428).
The devices comply with EN 61800-3: 2004 suitable for Category C1 and C2 environments.
DC braking, energy recovery (up to 100% of the output power)
IP20 chassis units
LO base load power without derating
HO base load power without derating
LO/HO base load power with derating:
For details, see Restrictions for special ambient conditions (Page 428).
-40 °C ... +70 °C
< 95% - condensation not permissible
Protected according to pollution degree 2 to EN 61800-5-1: 2007
EN 60721-3-3; 1995
Long-term storage in the transport packaging according to Class 1M2 to EN 60721-3-1:
•
1997
Transport in the transport packaging according to Class 2M3 to EN 60721-3-2: 1997
•
Vibration during operation according to Class 3M2 to EN 60721-3-3: 1995
•
without derating:
up to 1000 m above sea level
with derating:
up to 4000 m above sea level
UL, CE, CE, SEMI F47
The drive only satisfies the UL requirements when UL-certified fuses are used.
Technical data
10.2 Technical data, Power Modules
0 °C ... +40 °C
0 °C ... +50 °C
Up to 60° C
For details, see Restrictions for special
ambient conditions (Page 428)
415
Advertisement
Table of Contents
