Transferring The Setting From The Memory Card - Siemens SINAMICS G120 Operating Instructions Manual

Backing up data and series commissioning
7.1 Backing up and transferring settings using a memory card
Procedure with BOP-2
Proceed as follows to back up your settings on a memory card:
1.
2.
3.
4.
5.
6.
You have backed up the settings of the inverter on the memory card.
7.1.2

Transferring the setting from the memory card

Automatically transferring
Precondition
The inverter power supply has been switched off.
Procedure
Proceed as follows to automatically transfer your settings:
1. Insert the memory card into
the inverter.
2. Then switch on the inverter
power supply.
If there is valid parameter data on the memory card, then the inverter accepts the data from
the memory card.
314
If a USB cable is inserted in the inverter, withdraw it.
Go to the "OPTIONS" menu.
In the "OPTIONS" menu, select "TO CARD".
Set the number of your data backup. You can back up 99 different
settings on the memory card.
Start data transfer with OK.
Wait until the inverter has backed up the settings to the memory card.
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB