Siemens SINAMICS G120 Operating Instructions Manual page 364

Alarms, faults and system messages
9.5 List of alarms and faults
Number Cause
A07910 Motor overtemperature
A07920 Torque/speed too low
A07921 Torque/speed too high
A07922 Torque/speed out of tolerance
F07923 Torque/speed too low
F07924 Torque/speed too high
A07927 DC braking active
A07980 Rotary measurement activated
A07981 No enabling for rotary measure-
ment
A07991 Motor identification activated
F08501 Setpoint timeout
F08502 Monitoring time, sign-of-life expired •
F08510 Send configuration data not valid
A08511 Receive configuration data not
valid
A08526 No cyclic connection
A08565 Consistency error affecting adjust-
able parameters
F08700 Communications error
F13100 Know-how protection: Copy protec-
tion error
364
Remedy
Check the motor load.
Check the motor's ambient temperature.
Check the KTY84 sensor.
Check the overtemperatures of the thermal model (p0626 ... p0628).
The torque deviates from the torque/speed envelope curve.
Check the connection between the motor and the load.
•
Adapt the parameterization corresponding to the load.
•
Check the connection between the motor and the load.
•
Adapt the parameterization corresponding to the load.
•
Not required
Not required
Acknowledge pending faults.
Establish missing enables (see r00002, r0046).
Switch on the motor and identify the motor data.
Check the PROFINET connection.
•
Set the controller into the RUN mode.
•
If the fault occurs repeatedly, check the monitoring time set p2044.
•
Check the PROFINET connection.
Check the PROFINET configuration
•
Activate the controller with cyclic operation.
•
Check the parameters "Name of Station" and "IP of Station" (r61000,
•
r61001).
Check the following:
IP address, subnet mask or default gateway is not correct.
•
IP address or station name used twice in the network.
•
Station name contains invalid characters.
•
A CAN communications error has occurred. Check the following:
Bus cable
•
Baud rate (p8622)
•
Bit timing (p8623)
•
Master
•
Start the CAN controller manually with p8608 = 1 after the cause of the
fault has been resolved!
The know-how protection and the copy protection for the memory card
are active. An error occurred when checking the memory card.
Insert a suitable memory card and switch the inverter supply voltage
•
temporarily off and then on again (POWER ON).
Deactivate the copy protection (p7765).
•
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Converter with CU230P-2 Control Units