Uploading To The Memory Card; Recommended Memory Cards - Siemens SINAMICS G110M Operating Instructions Manual

Uploading the converter settings

6.2 Uploading to the memory card

6.2 Uploading to the memory card
6.2.1

Recommended memory cards

Function description
Table 6-1
Scope of delivery
Memory card without firmware
Memory card with firmware V4.7
Memory card with firmware V4.7 SP3
Memory card with firmware V4.7 SP6
Memory card with firmware V4.7 SP9
Memory card with firmware V4.7 SP10
Memory card with firmware V4.7 SP13
Further information
Using memory cards from other manufacturers
The converter only supports memory cards up to 2 GB. SDHC cards (SD High Capacity) and SDXC
cards (SD Extended Capacity) are not permitted.
If you use a different SD memory card, then you must format it as follows:
• Insert the card into your PC's card reader.
• Command to format the card:
format x: /fs:fat or format x: /fs:fat32 (x: Drive code of the memory card on your PC.)
Functional restrictions with memory cards from other manufacturers
The following functions are either not possible – or only with some restrictions – when using
memory cards from other manufacturers:
• Licensing functions is only possible using the recommended memory cards.
• Know-how protection is only possible with one of the recommended memory cards.
• In certain circumstances, memory cards from other manufacturers do not support writing or
reading data from/to the converter.
138
Memory cards to back up converter settings
Article number
6SL3054-4AG00-2AA0
6SL3054-7EH00-2BA0
6SL3054-7TB00-2BA0
6SL3054-7TD00-2BA0
6SL3054-7TE00-2BA0
6SL3054-7TF00-2BA0
6SL3054-7TG00-2BA0
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL