Aborting A Printing Operation; Deleting The Received Data (Data Clear); Moving The Y-Bar; Deleting The Received Data (Data Clear).2-18 - MIMAKI JFX200-2513EX Operation Manual

Chapter 2 Basic Usage
4
Remove the media after the completion of printing.
(1) Move the Y-bar outside the table.
"Moving the Y-bar" (P. 2-18)
(2) Press the [VACUUM] key to turn off suction.
(3) Take out the media.
• The media may get lifted and the print may get aborted due to the heat generated by the LED UV during
printing.
Reset the new media and start printing.

Aborting a Printing Operation

To stop printing halfway through, perform the following operations:
1
Press the [REMOTE] key while printing.
• The printing operation stops.
• Stop any data transfer from the PC by interrupting the process from the PC.
• If you press the [REMOTE] key again, the printing operation restarts from the point at which the
printing operation was aborted.

Deleting the Received Data (Data Clear)

If you want to stop printing, delete the already received data.
1
Press the [DATA CLEAR] key in LOCAL.
2
Press the [ENTER] key.
• Deletes the received data and returns to LOCAL mode.

Moving the Y-bar

The Y-bar can be moved to check the print results or to perform similar operations.
Set the Y-bar retracting position (VIEW position) in advance.
Setting the VIEW Position
1
Press the [FUNCTION] key in LOCAL.
2-18
<LOCAL>
DATA REMAIN
DATA CLEAR
[ENT]
**DATA CLEAR**
FUNCTION
VIEW [ENT]