List Of Functions - MIMAKI JFX200-2513EX Operation Manual

Chapter 3 Convenient Usage

List of Functions

This section outlines the various functions and describes their settings.
• Default "HOST" function
The value specified in the RIP software runs this function. When a value other than "HOST" is specified,
the specified value is used instead of waiting for instructions from the RIP software.
Note that some functions may not be available depending on the RIP software used. In such cases, the
value "When there are no instructions from RIP".
• For how to specify values in the RIP software, see the RIP software guide.
Function name
DROP.POScorrect
"Correcting the Drop Position" (P. 3-9)
LOGICAL SEEK
"Setting LOGICAL SEEK" (P. 3-11)
INK LAYERS
"Other Settings" (P. 3-24)
UV LEVEL
"Setting UV LEVEL" (P. 3-13)
REFRESH
"Other Settings" (P. 3-24)
MAPS
"MAPS Function" (P. 3-15)
MAPS2
WORK CHANGE
"WORK CHANGE Settings" (P. 3-19)
IONIZER
"Ionizer Settings" (P. 3-20)
AUTO CLEANING
"AUTO
PAGE
CLEANING
Settings" (P. 3-21)
INTERVAL WIPING
"Setting Nozzle Surface Cleaning
Frequency" (P. 3-23)
*1. It is set to the underlined value at the time of purchase.
*2. This is the value used for printing when the value set in the machine is to be prioritized or if no value is set in the RIP software (host), even if the type
registration of this machine is set to "HOST".
3-8
Available
settings
-40.0 to 0.0 to
40.0
HOST/ON/
OFF
HOST/1 to 9
HOST/
MANUAL
HOST/Lv.0
(long refresh
interval) to 3
(short refresh
interval)
OFF/MAPS2
AUTO
MANUAL PATTERN (1
to 4)/
SMOOTHING
LV. (AUTO/5
to 100%)
HOST/ON/
OFF
ON/OFF
OFF/PAGE
INTERVAL 1 to 3 to 1000
TYPE NORMAL/
SOFT/HARD
ON/OFF
If there is no
*1
instruction
*2
from RIP
——— Adjusts the dot position in
reversible printing.
ON Sets the scan movable area
during printing.
1 Sets the number of layers in
which ink is to be applied.
MANUAL Specifies the UV irradiation
pattern during printing.
Lv.3 Refreshes the ink heads during
printing.
——— Performs settings to reduce
stripes between the passes.
———
———
——— Sets the operations to complete
the printing.
——— Sets an optional IONIZER.
——— Sets up automatic head cleaning
to be performed before or during
———
printing.
———
——— Sets up the wiping operation
performed during printing.
Outline