Print Operations During "Nozzle Missing" Judgment And Error Occurrence; Printing Nozzle Check Settings - MIMAKI JFX200-2513EX Operation Manual

Chapter 3 Convenient Usage
4.
Auto nozzle recovery → judgment
If more missing nozzles than the "Judgment Condition" are still detected in the last judgment, it is judged that
printing cannot continue, and printing stops.
– This applies when "AUTO NOZZLE RECOVERY" is set to "ON".
5.
Nozzle missing judgment
Finally, if more missing nozzles than the "Judgment Condition" are still detected, it is judged that printing
cannot continue, and printing stops.
Print Operations During "Nozzle Missing" Judgment and Error
Occurrence
• Printing stops if "Nozzle Missing" is judged.
– Printing stops.
• When an error occurs during nozzle check
– Printing stops and [Printing Nozzle Check] is automatically set to "OFF". After recovering from the
error, re-configure "Printing Nozzle Check".

Printing Nozzle Check Settings

Set this to "on if you want to perform nozzle check when starting online printing.
1
Press the [FUNCTION] key in LOCAL.
2
Press
3
Press the [ENTER] key.
4
Press
• Available settings: ON/OFF
• Select "OFF" to disable Printing Nozzle Check.
5
Press the [ENTER] key, and select [Check Interval].
3-34
FUNCTION
VIEW
to select [NOZZLE CHECK].
FUNCTION
NOZZLE CHECK
NOZZLE CHECK
: Printing Check
to select "ON" and press the [ENTER] key.
Printing Check
=
Printing Check
：Check Interval
[ENT]
[ENT]
ON