Head Cleaning - MIMAKI JFX200-2513EX Operation Manual

Head Cleaning

Check the printed test pattern results and perform cleaning depending on the symptoms.
Head cleaning can be done in three ways. Use them based on the pattern print results.
1
Press the [CLEANING] key in LOCAL mode.
2
Press
• SOFT:
When lines are bent or missing
• NORMAL:
When one or more lines are missing or are composed of mixed colors
• HARD:
When poor image quality cannot be corrected even if cleaning is performed in NORMAL or SOFT
mode
3
Press the [ENTER] key.
4
Press to select the head for cleaning.
• Available settings:
1 2 3 (all the heads)
1 _ _ (head 1)
_ 2 _(head 2)
_ _ 3 (head 3)
5
Press the [ENTER] key.
6
Run the test print again and check the print results.
• Repeat the cleaning and test printing until the print results are normal.
CLEANING
SOFT
to select a cleaning type.
CLEANING
NORMAL
SELECT HEAD
: 1 2 3
SELECT HEAD
: 1 _ _
Head1
Rear side
of this
machine
**CLEANING**
PLEASE WAIT
[ENT]
[ENT]
Head2
Head3
Chapter 2 Basic Usage
2-15
2