Maintenance Of Head Surroundings - MIMAKI JFX200-2513EX Operation Manual

Chapter 4 Maintenance

Maintenance of Head Surroundings

Extremely minute mechanisms are used for the head, and therefore proper care must be taken when
performing maintenance.
Some gel-like ink or dust may be stuck in the bottom part of the slider and around the head. Rub it off using
a clean stick or another similar tool. When rubbing, make sure you never rub the nozzle part of the head.
Tools required for
cleaning
• If the ink gets on your skin or your clothes, rinse it out immediately with soap or water. In case the ink gets
in your eyes, rinse it out immediately with water and consult a doctor.
• When handling ink and washing liquid, pay close attention to ventilation and be sure to wear the included
safety glasses and gloves. The ink or washing liquid may get in your eyes.
• Make sure you clean the bottom surface of the carriage everyday so that it does not get dirty from ink or
dust. If it is left dirty, dirt or hardened ink may smear onto the nozzle due to wiper operation during head
cleaning.
• When you clean the bottom surface of the carriage, be careful so as not to rub the nozzle.
1
Remove the cover on the right side of the Y-bar.
• Remove the screws (2 places) and remove the cover.
2
Press the [MAINT.] key in LOCAL.
3
Press the [ENTER] key.
4
Press
5
Press the [ENTER] key.
• Carriage moves to the left edge of the machine.
4-16
• Cleaning Stick for Head
Surrounding (PN :
SPC-0527)
CARRIAGE OUT
MOVE POSITION
: STATION MAINT.
to select [HEAD MAINT.].
MOVE POSITION
: HEAD MAINT.
• Safety glasses
[ENT]
• Gloves