Printing Data; Starting A Printing Operation; Stopping A Printing Operation; Deleting Received Data (Data Clear) - MIMAKI TS55-1800 Operation Manual

Printing Data

Starting a Printing Operation

• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
1
Setting a Media (
2
Transmit data to be printed from the PC.
• The status indicator lamp blinks and the printing
conditions are displayed.
• For the method of data transmission, see the
instruction manual for the output software.
Resolution
The current setting number.
REMOTE <Setup 1>
720x600 16p / Bi / Hi / Vd
WF1 / S / NRS 0.0m
POST1 POST2
30° /40° 30° /35°
Waveform
Operating status of the nozzle recovery.
OFF: Print mode without registration or
recovery inoperable.
NRS: During operation
(possible to recover all nozzles).
NRS : During operation (some of the nozzle
recovery is unfeasible)
MAPS4 setting
S :AUTO (Standard)
Q :AUTO (Quality)
M :MANUAL
3
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.
P.2-4)
16p : Number of passes
Bi : Scan direction
Uni/ Unidirectional
Bi/ Bidirectional
Hi : Scanning speed
Std/ Standard speed
Hi/ Double speed
Vd : Data type
Vd/ Variable data
Nd/ Normal data
The length of media
printed
Chapter 2 Basic Operation

Stopping a Printing Operation

Perform the following operation when stopping a printing
operation halfway.
1
Press the
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.

Deleting Received Data (Data Clear)

When you want to stop printing, delete the already
received data.
1
Press the
(DATA CLEAR) in LOCAL.
2
Press the
• The received data is erased then it returns to the
Local.

Cutting a media

By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press
• It enters into the origin setting mode.
• By pressing [], feed the media to the cutting
position.
Origin Set
X Position
0.0
2
Press the
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.
(LOCAL) during printing.
key, and then press the
key.
.
Y Position
0.0
key.
2-13
2
2
2
5
6