Error Message - MIMAKI JFX200-2513EX Operation Manual

Chapter 5 Troubleshooting
Message
INK COLOR
: ---- YYKK
WRONG INK BOTTLE
: ---- YYKK
NO INK BOTTLE
: ---- YYKK
EXPIRATION
: ---- YYKK
Expiration:1MONTH
: ---- YYKK
Expiration:2MONTH
: ---- YYKK

Error message

When an error message is displayed, eliminate the error according to the following table.
Message
CAN'T OPERATE
: INK ERROR
CAN'T OPERATE
: DATA REMAIN
ERROR 04
PARAM ROM
ERROR 108
HD CONNECT [1 2 3 4 5 6 7 8 9 10 11 12]
ERROR 108
HD THERMIS [1 2 3 4 5 6 7 8 9 10 11 12]
ERROR 12a
HDC SPEED
ERROR 12e
Head Failed [x x x x]
ERROR 122
CHECK : SDRAM
ERROR 128
HDC FIFO OVER
ERROR 128
HDC FIFO UNDER
5-10
Cause
The color of ink in the ink
bottle is of a different type
than the currently supplied
ink.
An error occurred in the Ink
IC chip information of the
ink bottle.
Ink bottle is not set in the
external ink supply unit.
The specified expiration
date of the ink bottle has
passed.
The specified expiration
date of the ink bottle has
passed (one month has
passed after the expiration
date).
The specified expiration
date of the ink bottle has
passed (two months have
passed after the expiration
date).
Cause
An ink error occurred.
Data is being received.
There is an abnormality in
the parameters.
Head connection cannot be
confirmed.
Head temperature cannot
be read.
Abnormality occurred in the
ink discharge waveform.
Abnormality of the head
and waveform driver
occurred.
There is no PRAM.
• Data transmission
speed is too fast.
• Control circuit board is
defective.
• Data transmission
speed is too slow.
• Control circuit board is
defective.
Solution
• Check the color of the ink bottle for
which the warning occurred.
• Replace the ink bottle for which the
warning occurred.
• Set the ink bottle on the bottle
holder for which the warning
occurred.
• The expiration date has passed.
However, you can use it until the
end of the following month.
• One month has passed after the
expiration date.
However, you can continue to use
it until the end of the month (the ink
bottle lamp blinks red).
• Two months have passed after the
expiration date.
Replace the cartridge for which the
warning occurred.
Solution
• Check the ink bottle of the supply
path corresponding to the indicated
color.
• Clear the data.
"Deleting the Received Data
(Data Clear)" (P. 2-18)
• Turn off the power on the machine
and turn it on after a while.
If displaying again, contact your
local distributor, our sales office, or
service center.