Disposing The Waste Ink - MIMAKI JFX200-2513EX Operation Manual

Chapter 4 Maintenance
3
Install the new carriage filter (PN : SPC-0851).
• Carriage filters are on the left, right, and back side of the carriage.
Replace all the filters at same time.
4
Once the replacement is complete, press the [ENTER] key.

Disposing the Waste Ink

The ink used in head cleaning and other functions is stored in the waste ink tank on the lower right side of
the machine. The machine counts the accumulated amount of discharged ink, and a message is displayed
prompting the user to check the tank once the specified amount is reached. Consider replacing the waste ink
tank when this message is displayed.
• The message is displayed when the amount of discharged ink reaches 80% (2.1 L) of the 2.6 L tank.
Confirmation message in LOCAL
1
The message on the right is displayed.
2
Check the waste ink tank.
• If the displayed amount is different from the actual amount, press
• If you correct the amount to less than 80% and press the [ENTER] key, the message disappears.
• When replacing (disposal) and clearing the count, perform the following procedure.
"Disposing of Waste Ink" (P. 4-35)
• The waste ink might start overflowing from the waste ink tank if you simply delete the message by pressing
the [ENTER] key and continue using the printer without disposing of the waste ink.
4-34
New carriage
filter
<LOCAL>
Check waste ink
Check waste ink
Level : 80% (2.1L)
[MNT]
to correct.