Replacing The Waste Ink Tank Before The Waste Ink Tank Confirmation Message Is Displayed (1) - MIMAKI JFX200-2513EX Operation Manual

5
Select [InkTankExchange] from the MAINTENANCE menu.
(1) Press the [FUNCTION] key in LOCAL.
(2) Press
(3) Press
6
Press the [ENTER] key to release.
Replacing the waste ink tank before the waste ink tank confirmation
message is displayed (1)
When replacing the waste ink tank before the waste ink tank confirmation message is displayed (before
reaching 80% (1.6 L) of the 2 L tank), set the waste ink information to 0% on the INFORMATION menu.
1
Empty the waste ink tank.
• "Disposing of Waste Ink" (P. 4-35)
2
Press the [FUNCTION] key in LOCAL.
3
Press
• For firmware version 1.90 or later, you can also run this procedure from the MAINTENANCE
menu. For procedure from [MAINTENANCE], see
waste ink tank confirmation message is displayed (2)" (P. 4-38).
4
Press the [ENTER] key.
5
Press
6
Press the [ENTER] key several times until the waste ink tank information is displayed.
7
Press [MAINT.] key.
to select [MAINTENANCE], and press the [ENTER] key.
to select [InkTankExchange].
MAINTENANCE
InkTankExchange
InkTankExchange
EXCHANGE
FUNCTION
SETUP
to select [INFORMATION].
FUNCTION
INFORMATION
INFORMATION
USAGE
to select [USAGE].
WASTE INK TANK
=
Check waste ink
Level : 60% (1.5L)
Chapter 4 Maintenance
[ENT]
[ENT]
[ENT]
"Replacing the waste ink tank before the
[ENT]
[ENT]
60%
4
4-37