Configuring The Brocade 8000 Switch - Chelsio Communications Terminator Series Installation And User Manual

Chapter XIII. Data Center Bridging (DCB)
v. On the FC Ports, if a FC target is connected then perform the following steps -
switch(config)#vsan database
switch(config-vsan-db)#vsan 2
switch(config-vsan-db)# vsan 2 interface fc 2/2
switch(config-vsan-db)#exit
switch(config)interface fc 2/2
switch(config-if)# switchport mode auto
switch(config-if)# switchport speed auto
switch(config-if)# no shutdown.
vi. If you have not created a zone then make sure the default-zone permits the VSAN created,
otherwise the initiator and the target on that particular VSAN although FLOGI'd into the switch
will not talk to
switch(config)# zone default-zone permit vsan 2
4.2.

Configuring the Brocade 8000 switch

i. Configure LLDP for FCoE. Example of configuring LLDP for 10-Gigabit Ethernet interface.
switch(config)#protocol lldp
switch(conf-lldp)#advertise dcbx-fcoe-app-tlv
switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv
ii. Create a CEE Map to carry LAN and SAN traffic if it does not exist. Example of creating a
CEE map.
switch(config)# cee-map default
switch(conf-cee-map)#priority-group-table 1 weight 40 pfc
switch(conf-cee-map)#priority-group-table 2 weight 60
switch(conf-cee-map)#priority-table 2 2 2 1 2 2 2 2
Chelsio Unified Wire for Linux
each other. To enable it, execute the below command.
220