Uefi Pxe Boot - Chelsio Communications Terminator Series Installation And User Manual
Unified wire for linux
Hide thumbs
Also See for Terminator Series:
- Installation and user manual (48 pages) ,
- Installation and user manual (54 pages) ,
- Installation and user manual (26 pages)
Table of Contents
Advertisement
Chapter XXV. Unified Boot
5.2.
uEFI PXE Boot
•
Only uEFI v2.3.1, v2.4 and v2.5 supported.
Important
•
Any other uEFI version is NOT SUPPORTED and may render your system
unusable.
This section describes the method to configure and use Chelsio uEFI PXE interfaces.
i.
Reboot the system and go into the BIOS setup.
ii.
Disable Secure Boot, if not already done.
iii. Chelsio HII should be listed as Chelsio T5/T6. Highlight it and press [Enter].
If Chelsio T5/T6 is not listed, please ensure that Chelsio uEFI driver is loaded
Note
correctly as mentioned
iv. Select the Chelsio adapter to be configured and press [Enter].
v.
Select Configuration Utility and press [Enter].
Chelsio Unified Wire for Linux
here
in the Flashing Firmware and Option ROM section.
372
Advertisement
Table of Contents
Need help?
Do you have a question about the Terminator Series and is the answer not in the manual?
Questions and answers