Installing Chelsio Unified Wire From Rpm - Chelsio Communications Terminator Series Installation And User Manual

Chapter I. Chelsio Unified Wire
▪
The default configuration tuning option is Unified Wire. The configuration tuning can be
selected using the following commands:
[root@host~]# make CONF=<configuration_tuning> <Build Target>
[root@host~]# make CONF=<configuration_tuning> <Install Target>
▪
To build and install drivers along with benchmarks:
[root@host~]# make BENCHMARKS=1
[root@host~]# make BENCHMARKS=1 install
▪
The drivers will be installed as RPMs or Debian packages (for ubuntu). To skip this and
install drivers:
[root@host~]# make SKIP_RPM=1 install
▪
The installer will remove the Chelsio specific drivers (inbox/outbox) from initramfs. To skip
this and install drivers:
[root@host~]# make SKIP_INIT=1 install
▪
The installer will check for the required dependency packages and will install them if they
are missing from the machine. To skip this and install drivers:
[root@host~]# make SKIP_DEPS=1 install
•
To view the different configuration tuning options, view the help by typing
Note
[root@host~]#make help
•
If IPv6 is administratively disabled in the machine, the drivers will be built and
installed without IPv6 Offload support by default.
3.6.

Installing Chelsio Unified Wire from RPM

•
IPv6 should be enabled in the machine to use the RPM Packages.
Note
•
Drivers installed from RPM Packages do not have DCB support.
•
DPDK installation not supported.
Chelsio Unified Wire for Linux 32