Hp Firmware Management Protocol (Fmp) - Chelsio Communications Terminator Series Installation And User Manual

Chapter XXV. Unified Boot
3.4.

HP Firmware Management Protocol (FMP)

Enabling FMP
For HP machines with Unified Boot v1.0.0.99 and below installed, FMP must be manually
enabled. For v2.0.0.1 and above, you can skip to the next sub-section for instructions on how to
upgrade firmware using FMP.
i. Prepare USB flash drive as described here.
ii. Boot system to EFI shell and change your working directory to CHELSIO.
drivers
iii. Issue command
see a similar output:
iv. Note the handle and unload the driver using the following syntax:
FS1:\CHELSIO\> unload -n <driver_handle>
Example:
v. Load the uEFI driver (ChelsioUD.efi) present in the CHELSIO directory.
vi. If Chelsio uEFI driver was loaded successfully in the previous step, run the command
fwupdate -l and Chelsio T6 CNA should be listed as shown below:
Chelsio Unified Wire for Linux
to determine if Chelsio uEFI driver is loaded. If loaded, you should
362