Chelsio Communications Terminator Series Installation And User Manual page 193

Chapter XI. iSCSI PDU Offload Initiator
i. The interface file needs to be created in
Note
ii. If
ethX's IP address or an address on the same subnet. Make sure the IP
address is unique in the network.
Discovery and Login
i. Starting iSCSI Daemon
Start Daemon from /sbin by using the following command:
[root@host~]# iscsid
iscsid
If is already running, then kill the service and start it as shown above after
Note
installing the Chelsio Unified Wire package.
ii. Discovering iSCSI Targets
To discover an iSCSI target, execute the command in the following format:
[root@host~]# iscsiadm -m discovery -t st -p <target ip address>:<target
port no> -I <cxgb4i iface file name>
Example:
[root@host~]# iscsiadm -m discovery -t st -p 102.2.2.155:3260 -I
cxgb4i.00:07:43:04:5b:da
iii. Logging into an iSCSI Target
Log into an iSCSI target using the following format:
[root@host~]# iscsiadm -m node -T <iqn name of target> -p <target ip
address>:<target port no> -I <cxgb4i iface file name> -l
Chelsio Unified Wire for Linux
iface.ipaddress
is specified, it needs to be either the same as the
/etc/iscsi/ifaces/
directory.
193