Chelsio Communications Terminator Series Installation And User Manual page 180

Chapter X. iSCSI PDU Offload Target
-g
-G <var=const>
-s target=<name>
-S target=<name>
Chelsio Unified Wire for Linux
To flush all the targets in the system:
iscsictl -F
To flush a particular target:
iscsictl -F target=iqn.com.cc.it1
To flush only the lun 0 of a particular target:
iscsictl -F target=iqn.com.cc.it1 -k lun=0
Display the Chelsio iSCSI Global Entity Settings.
Set the Chelsio iSCSI Global Entity Settings.
var=const parameter:
Where var=const can be any key listed under
Chelsio Global Entity Settings.
Example:
iscsictl -G iscsi_auth_order=ACL
The var=const parameter(s) are mandatory.
If the var=const parameter is not specified, the
command will be denied.
If any of the specified var=const parameter is
invalid, the command will reject only the invalid
parameters, but will continue on and complete all
other valid parameters if any others are
specified.
Stop the specified active iSCSI targets.
target=<name> parameter:
See the description of option -c for the
target=<name> parameter definition.
The target=<name> parameter is mandatory. If
no target=<name> parameter is specified, the
command will be denied.
If the target=<name> parameter is specified,
only the specified targets from the
target=<name> parameters will be stopped.
If target=ALL is specified, all active targets will
stop.
Start or reload the iSCSI targets.
target=<name> parameter:
Where name is the name of the target(s) that will
be started or reloaded.
The target=<name> parameter can be specified
as one or more parameter on the same
command line, separated by a space,
target=<name1> target=<name2> ...
target=<nameN>
The target=<name> parameter can also be,
target=ALL
180