Chelsio Communications Terminator Series Installation And User Manual page 167

Chapter X. iSCSI PDU Offload Target
ACL_Enable
ACL
Chelsio Unified Wire for Linux
"Yes" "No"
"No"
[iname=<name1>][
;<sip=<sip1>][;d
ip=<dip1>][;lun=
<lun_list:permis
sions>]
NOTE: FILE mode is the most
versatile mode, if in doubt use FILE
mode.
Defines if Chelsio'sAccess Control
No
List (ACL) method will be enforced
on the target:
Yes: ACL is enforced on the target
No: ACL is not enforced on the
target
NOTE: ACL flag is not allowed to be
updated on the fly. Target must be
restarted for new ACL flag to take
effect.
Yes The ACL specifies which initiators
and how they are allowed to access
the LUNs on the target.
iname=<Initiator Name> specifies
one or more initiator names, the
name must be a fully qualified iSCSI
initiator name.
sip=<Source IP address> specifies
one or more IP addresses the
initiators are connecting from.
Dip=<Destination IP address>
specifies one or more IP addresses
that the iSCSI target is listening on
(i.e., the target portal IP addresses).
NOTE: when configuring an ACL at
least one of the above three must be
provided:
•
iname, and/or
•
sip, and/or
•
dip.
lun=<lun list>:<permission>
controls how the initiators access
the luns.
The supported value for <lun list> is
ALL.
<permissions> can be:
R: Read Only
RW or WR: Read and Write
If permissions are specified then the
associated LUN list is required.
If no lun=<lun list>:[R|RW] is
specified then it defaults to
ALL:RW.
NOTE: For the Chelsio Target
Software release with lun-masking
included,
<lun list> is in the format of <0..N |
0~N | ALL>
Where:
167