Software/Driver Unloading; Unloading The Lio Iscsi Target Offload Driver; Unloading The Nic Driver - Chelsio Communications Terminator Series Installation And User Manual

Unified wire for linux

Hide thumbs Also See for Terminator Series:

Table of Contents

Chapter IX. LIO iSCSI Target Offload

Software/Driver Unloading

To unload the LIO iSCSI Target Offload kernel module, follow the steps mentioned below:

Log out from the initiator.

ii. Run the following command:

[root@host~]# echo 0 >

/sys/kernel/config/target/iscsi/<target_iqn>/tpgt_1/np/<target_ip>\:3260/cxg

Execute the above command for every portal address listening on Chelsio interface.

iii. Unload the driver:

[root@host~]# rmmod cxgbit

To unload the NIC driver, run the following command:

[root@host~]# rmmod cxgb4

Chelsio Unified Wire for Linux

Do you have a question about the Terminator Series and is the answer not in the manual?

Terminator 6