Chelsio Communications Terminator Series Installation And User Manual page 30

Chapter I. Chelsio Unified Wire
Chelsio's Unified Wire package allows installing iWARP drivers on multiple Cluster nodes with a
single command. Follow the procedure mentioned below:
i. Change your current working directory to Chelsio Unified Wire package directory:
[root@host~]# cd ChelsioUwire-x.x.x.x
ii. Create a file (machinefilename) containing the IP addresses or hostnames of the nodes in
the cluster. You can view the sample file, sample_machinefile, provided in the package to
view the format in which the nodes have to be listed.
iii. Now, execute the following command:
[root@host~]# ./install.py -C
iv. Select the required configuration tuning option. The tuning options may vary depending on
the Linux distribution.
v. Select the required Cluster Configuration.
vi. If you already have the required version of OFED software installed, select Skip-OFED. To
install OFED 4.8-2 choose the Install-OFED option.
vii. The selected components will now be installed.
The above commands will install iWARP (iw_cxgb4) and TOE (t4_tom) drivers on all the nodes
listed in the machinefilename file.
CLI mode
i. Download the Unified Wire driver package from
ii. Untar the tarball using the following command:
[root@host~]# tar zxvf ChelsioUwire-x.x.x.x.tar.gz
iii. Change your current working directory to Chelsio Unified Wire package directory and build
the source:
[root@host~]# cd ChelsioUwire-x.x.x.x
[root@host~]# make
Chelsio Unified Wire for Linux
-m <machinefilename>
Chelsio Download Center.
30