Installation On Iscsi Lun - Chelsio Communications Terminator Series Installation And User Manual

Chapter XXV. Unified Boot
9.3.

Installation on iSCSI LUN

If you are installing using CD/DVD, please make sure that the USB drive with DUD image
is inserted. Also, change the boot priority to boot from CD/DVD in the BIOS setup.
i. Insert the OS installation disc into your CD/DVD ROM.
ii. On the Grub menu, choose Install or upgrade an existing system option if not
already selected.
iii. Depending on the boot mode selected and Linux distribution installed, use the
appropriate option to select Chelsio iSCSI Initiator driver as the SCSI transport
medium:
•
•
iv. Load Chelsio Driver Update Disk depending on the Linux distribution
for RHEL 7.X;
If you are installing from a PXE server, please refer 8.1. Installation using Chelsio
DUD(Click here
SPx) section to load Chelsio Driver Update Disk.
After successfully loading Chelsio DUD, follow the procedure mentioned below to
continue installation, based on the distribution.
Chelsio Unified Wire for Linux
Legacy
o For RHEL 6, press Tab and then type dd.
o For RHEL 7, press Tab and then type ip=ibft
o For SLES, press Tab and then type dd.
uEFI
o For RHEL 6, type e and then type dd.
o For RHEL 7, type e and then type ip=ibft
o For SLES, type e and then type dd.
Click here for RHEL 6.X;
for RHEL 7.X; Click here
Click here for SLES 15/SLES 12 SPx.
for RHEL 6.X; Click here
(Click here
for SLES 15/SLES 12
420