Chelsio Communications Terminator Series Installation And User Manual page 29

Chapter I. Chelsio Unified Wire
CLI mode (without Dialog utility)
If your system does not have Dialog or you choose not to install it, follow the steps mentioned
below to install the Unified Wire package:
i. Download the Unified Wire driver package from
ii. Untar the tarball using the following command:
[root@host~]# tar zxvf <driver_package>.tar.gz
iii. Change your current working directory to Chelsio Unified Wire package directory:
[root@host~]# cd ChelsioUwire-x.x.x.x
iv. Run the following script to start the installer
[root@host~]# ./install.py -c <target>
v. Enter the number corresponding to the Configuration tuning option in the Input field and
press Enter.
vi. If you already have the required version of OFED software installed, select Skip-OFED. To
install OFED 4.8-2 choose the Install-OFED option.
This step will be prompted only for OFED supported platforms.
Note
vii. The selected components will now be installed.
After successful installation you can press 1 to view the installation log. Press any other key
to exit from the installer.
To customize the installation, view the help by typing
Important
[root@host~]#./install.py –h
viii. Reboot your machine for changes to take effect.
iWARP driver installation on Cluster nodes
Please make sure that you have enabled password less authentication with ssh
Important
on the peer nodes for this feature to work.
Chelsio Unified Wire for Linux
Chelsio Download Center.
29