Software/Driver Loading - Chelsio Communications Terminator Series Installation And User Manual

Chapter VIII. NVMe-oF

Software/Driver Loading

Please ensure that all inbox drivers are unloaded before proceeding with
Important
unified wire drivers.
[root@host~]# rmmod csiostor cxgb4i cxgbit iw_cxgb4 chcr cxgb4vf cxgb4
libcxgbi libcxgb
Follow the steps mentioned below on both target and initiator machines:
i. Load the following modules:
[root@host~]# modprobe iw_cxgb4
[root@host~]# modprobe rdma_ucm
ii. Bring up the Chelsio interface(s):
[root@host~]# ifconfig ethX x.x.x.x up
iii. Mount configfs by running the below command:
[root@host~]# mount -t configfs none /sys/kernel/config
iv. On target, run the following commands:
[root@host~]# modprobe null_blk
[root@host~]# modprobe nvmet
[root@host~]# modprobe nvmet-rdma
On initiator, run the following commands:
[root@host~]# modprobe nvme
[root@host~]# modprobe nvme-rdma
Chelsio Unified Wire for Linux 130