Chelsio Communications Terminator Series Installation And User Manual page 429

Chapter XXVI. Appendix A
Configuring Ethernet interfaces on Cisco switch
Always configure Ethernet interfaces on Cisco switch in trunk mode.
Binding VFC to MAC
If you are binding the VFC to MAC address in case of Cisco Nexus switch, then make sure you
make the Ethernet interface part of both Ethernet VLAN and FCoE VLAN.
Cisco nexus switch reporting "pauseRateLimitErrDisable"
If in any case the switch-port on the Cisco nexus switch is reporting
"pauseRateLimitErrDisable", then perform an Ethernet port shut/no shut.
"unexpected CM event" messages seen with iWARP traffic
One of the reason for this could be port number collisions. To fix this, use iWARP port mapper
(iwpmd).
[root@host~]# iwpmd
iWARP port mapper (iwpmd) has its own issues.
Note
Multiple Chelsio adapters
Chelsio Option ROM supports upto 4 Chelsio adapters in a macine. In case of using more than
4 adapters, it is recommened to disable the Option ROM on the adapters.
Installer issues
In case of any failures while running the Chelsio Unified Wire Installer, please collect the below:
•
install.log fille, if installed using install.py
•
Entire make command output, if installed using the makefile
Logs collection
In case of any driver/firmware issues, please run the below command to collect all the
necessary log files:
[root@host~]# chdebug
A compressed tar ball will be created with all the log files.
Chelsio Unified Wire for Linux 429